The pro-cap has a big five inch diameter with two full inches between each terminal! This ensures accurate spark delivery and far less chance of spark scatter inside the cap. The entire assembly is injection molded from DuPont? Rynite(TM) material for incredible strength and high dielectric properties. The rotor features a deep skirt and thick vanes to stir up the air to prevent ionization ant the rotor screws are even over molded with Rynite for increased spark isolation. The extra thick rotor tip can easily handle high heat and is indexed and firmly secured with two screws. The pro-cap is crowned with a screw-down retainer to keep all of the plug wires firmly attached to each terminal.
- 5 in. Dia.
- 2 in. Between Each Terminal For Improved Voltage Distribution
- Injection molded Rynite for strength and dielectric properties.
- Plug Wire Retainer holds the wires securely in place.
- Rotor tip is indexed and screwed
- Cap is vented on top
Holley Performance Emission Code 5: This part is legal for sale or use on Emissions Controlled Vehicles; Uncontrolled (Non-Emissions Controlled) Vehicles; and Racing Use Only Vehicles because it does not affect vehicle emissions and is not covered by emissions regulations
About MSD Ignition
Your performance electronic source for ignitions, coils, distributors, timing controls, spark plug wires, starters and electronic fuel injection.
Ask a question about
MSD Pro-Cap Distributor Cap And Rotor 7445: