YES, IT'S IN STOCK!
Units in stock: 5
Ships within 24 - 48 hours
Available for Pickup
Select a Vehicle or refer to the Vehicle Fitment Tab below to verify that this part fits your vehicle.
|Shipping Note:||Standard Delivery|
We'll find it for you. Give us a call at 877.454.7792 and we'll source that discontinued or hard to find part.
No Brokerage or Duties - Canadian Owned & Operated - Shipped from Canada to your Door - Easy to Navigate Website - Access to New, Used & Discontinued Parts - Full Time Staff to Answer your Questions.
Chevelle Depot always recommends professional installation of our products. Buyer assumes risk of damage caused by improper installation.
Best Quality Reproduction Windshield Stop Bracket Rubber Coated End Sold Individually Two Required per Car Butyl Glass Seal Available Separately as Part # 88-0119-3 Fits 1967-1969 1st Gen Camaro Coupes & Convertibles This windshield lower support bracket is a quality reproduction for your original 1967, 1968, or 1969 first generation Camaro. If you have taken out the front windshield on your standard Camaro, Super Sport (SS), Rally Sport(RS) or Z28 during your restoration, you have probably lost or damaged these support brackets. However, they are very important and need to be replaced! When the Camaro windshield is put in place over the butyl glass seal, these brackets keep the windshield from sliding down the windshield frame and becoming damaged or cracked. While sold separately, two are required to keep your windshield secure. Don't wait until your windshield glass is being replaced and you need this support bracket.
|Chevrolet||Chevelle||1968 - 1972|
Note: HTML is not translated!
Rating: Bad Good