|Availability:||Ordered From Supplier|
Estimated Ship Date 03/03/2020 (If Ordered Today)
Select a Vehicle or refer to the Vehicle Fitment Tab below to verify that this part fits your vehicle.
|Shipping Note:||Standard Delivery|
We'll find it for you. Give us a call at 877.454.7792 and we'll source that discontinued or hard to find part.
No Brokerage or Duties - Canadian Owned & Operated - Shipped from Canada to your Door - Easy to Navigate Website - Access to New, Used & Discontinued Parts - Full Time Staff to Answer your Questions.
Chevelle Depot always recommends professional installation of our products. Buyer assumes risk of damage caused by improper installation.
IMPORTANT: Electrical items are covered by a 30 day EXCHANGE ONLY WARRANTY. There are no returns or refunds on such items.Restoration Correct Wiring Harness Correct Color Coded Wires Correct Connectors Pre-Attached Correct Electrical Tape Wrap Supplies Power From Main Under Dash Harness To Power Antenna Extension Replaces Often Brittle, Broken Or Petrified Harnesses A Must For Any Restoration Fits 1966 1st Gen Big Block Chevelle Models (Except Convertibles) Picture May Differ Slightly From Actual Part A working wiring system is one of the most important safety features for your 1966 First Generation Chevelle. Years-old wiring that has been spliced, modified, is dry-rotted or in generally poor condition could lead to an untimely breakdown or much worse, a disastrous fire. For safety and functionality, replacing your old wiring harness with a new reproduction harness is a very smart investment. Each harness is manufactured according to GM specifications, assuring an authentic look and precise connection to all electrical components. This reproduction harness starts with the correct gauge wire, color-coded to match the factory wiring diagram and pre-attached connectors. The correct antenna wiring harness will supply power from the main under dash harness to the power antenna wiring extension. Each wire is cut to the exact length required and wiring terminals are crimped-on just like the originals. If specifications call for it, the terminals are also dip soldered to limit resistance voltage loss. Hand-assembly of the harness is completed by wrapping the wires with factory-correct, non-adhesive or cloth woven tapes, where applicable, providing a 100% original appearance.
Note: HTML is not translated!
Rating: Bad Good