If you need repairs in a small area then check out our floor pan halves. They are cut from our OE style full floors and have the same dimensions front to rear. Outside edge will meet with rocker panels and inside includes approximately 4-6 inches of the transmission hump.
Auto Metal Direct is a team of true car guys with years of experience in sheet metal reproduction, car restoration and paint/body work. We believe that quality is not subjective! Our mission is to provide the best customer experience for the Ford, Mopar and GM classic car markets - both in products and in service.
Our panels are made from proper gauge steel and include all correct-as-original clips, tabs, flanges, bends and seams. Each time a prototype body panel comes off of a new tooling, we test fit it on a car. The marked up prototype is then used to change and improve the tools, and a new prototype is produced. This procedure might be repeated multiple times but, once the part is finally approved, you can be assured of a quality part.
|Buick||Skylark||1964 - 1967|
|Buick||Special||1964 - 1967|
|Chevrolet||Chevelle||1964 - 1967|
|Chevrolet||El Camino||1964 - 1967|
|Chevrolet||Malibu||1964 - 1967|
|Oldsmobile||Cutlass||1964 - 1967|
|Pontiac||GTO||1964 - 1967|
|Pontiac||LeMans||1964 - 1967|
|Pontiac||Tempest||1964 - 1967|